1992 Johnson Evinrude "EN" 60 thru 70 Service Manual, P/N 508144, Page 267Get this manual
Cable InstallationEngine i cables are disconnected at batteryThrottle Cable 1Remove the rubber grommet from front of lower engine coverRemove cable retainerApply liberal amount of OMC TripleGuard grease to both anchor block pocketsf1l 2Extend throttle cable and lubricate with OMC Triple-Guard grease3Verify that the fast idle lever is down in the RUN position4While rotating the propeller shaft, move the remote control handle from NEUTRAL to the FORWARD detent and then halfway back to NEUTRALThis positions the control for proper throttle cable adjustmentFailure to follow this procedure exactly might cause accelerated wear of shift system components and high shifting effort5Move engine throttle lever tightly against idle stop screw'" To prevent accidental starting of engine, verify that battery