1992 Johnson Evinrude "EN" 60 thru 70 Service Manual, P/N 508144, Page 263Get this manual
Lubricate cable ends with OMC Tripe-Guard grease i11 '"
i To install throttle cable, move throttle lever arm from
4Begin cable installation with housing half of control
ehind plastic plate to expose hole in lever armDo not remove jastic separator plate from housingIf it is missing, cable pins fill fall outPlace eyelet of throttle cable between the halves of 1e throttle lever arm, in line with holesGrease cable pin and rop cable pin through upper lever arm, through eyelet, and into )wer lever arm
i2l 5Grease cable trunnion pocket and insert cable trunnion l
into trunnion pocket in housing half
:;:;] 6The throttle lever must be in the idle position before
reassemblyMove it forward, toward the front of the housing alf until it contacts the stopGrease cable pin, place eyelet of shift cable between the shift halves, and press cable trunnion into trunnion pocket in over halfInsert cable pin
W7To install shift cable, grease trunnion pocket in cover half