1992 Johnson Evinrude "EN" 60 thru 70 Service Manual, P/N 508144, Page 262Get this manual
26 "" 10 Installdetent roerdetent shoe
and spnng Into housing To prevent possible eye Injury from detent spring, wear safety glasses while installing shift and throttle plate
1271 11Place spring washer onto splined hub of shift and throttle plate 1281 12Be sure shift and throttle plate is cleanInstall shift and
throttle plate bushing into housingRetract detent spring and install shift and throttle plateTeeth of shift and throttle plate must engage teeth of shift lever assembly
1281 13Place neutral start switch mounting plate in positionInstall neutral start switch with two screwsTighten screws to torque of 15-20 inIbs(1,7-2,3 Nm) ment screw
28 14Install
adjust.ment lever with friction adjustInto hOUSing
1281 15Install retainer plate CD into housingTighten screw to torque of 25-35 inIbs(2,8-3,9 Nm)16Check to be sure no wires are pinchedLubricate shift lever post and three assembly screws with OMC Triple-Guard grease17Reassemble two halves of remote control, taking care to properly pilot the electrical cable grommet into the housingTighten screws to torque of 40-50 inIbs(4,6-5,5 Nm)18Pull up on the neutral lock slide, and install handle spline into