1992 Johnson Evinrude "EN" 60 thru 70 Service Manual, P/N 508144, Page 236Get this manual
Assembly 1Lubricate the armature shaft bearing surface with one drop of SAE No.1 oilLubricate pinion helix on armature shaft with OMC Starter Bendix Lube, OMC PIN 337016 f81 If removed, install retaining ring and washer on drive end of armature shaft
, pinionanti -drift springand spacer to drive end of armature shaftInstall new locknutUsing strap wrench to prevent damage to armature, tighten nut to torque of 240-300 inIbs 20-25 ftIbs(27-34 Nm)4Assemble armature to frame and magnet assembly, aligning
marks on drive cap end and frame
f81 3Assemble drive end cap
1nl 5Install insulated brush and terminal set in commutator
end cap with long lead in slotPosition the insulatorsflat washer CD, lock washer Q), and nut as shown in figure Reversing these brushes will cause motor to run backwards
(0)Screws secure ground brush leads and holderInsert insulated brushes in holdernotch and rib suitable tool for holding brushes in place can be made from putty knife