1992 Johnson Evinrude "EN" 60 thru 70 Service Manual, P/N 508144, Page 217Get this manual
1231 17Apply OMC Triple-Guard Grease or Lubriplate 777 to the handle end of the starter ropeUsing OMC Special Tool PIN 378774 (Starter Rope Threading Tool), thread the starter rope through the handlePress the starter rope into the channel of the rope anchor, with end of starter rope butting firmly against end of channelPress the anchor into the handle 18Check operation of the starter pawl when the starter rope is pulled outThe starter pawl should extend when the starter rope is pulled and retract when the starter rope recoils1241 19Install the starter lockout assembly to the starter housing using the shoulder screwTighten the shoulder screw securely Installation
12511261Position the starter assembly onto the motorPlace the lifting ring on the rear screw mounting bossInstall the five starter housing retaining screwsBe sure to place washers between the starter housing rubber mounts and the motorTighten the two starter housing screws and one nut to torque of 10-12 ftIbs(14-16 Nm)Tighten the two starter handle bracket screws to torque of 60-84 inIbs(7-9 Nm)