1992 Johnson Evinrude "EN" 60 thru 70 Service Manual, P/N 508144, Page 151Get this manual
Installation
["';l1Coat crankshaft splines with OMC Moly LubeDo not allow lubricant to pack at end of splinesLubricant here may prevent seating of driveshaft in crankshaftBe sure that the O-ring is in end of the crankshaft2Clean powerhead and exhaust adapter gasket surfacesInstall new exhaust adapter gasket dry, use no sealer3Use OMCUniversal Puller and Lifting Eye, PIN 321537, or OMC Lifting Fixture, PIN 396748, to lower the powerhead assembly into placeIf necessary, rotate the flywheel in clockwise direction to align crankshaft and driveshaft splinesrJl4Coat the threads of the exhaust housing to powerhead screws with OMC Gel Seal I and install themTorque the screws in stages to 18-20 ftIbs(25-27 Nm)