1992 Johnson Evinrude "EN" 60 thru 70 Service Manual, P/N 508144, Page 148Get this manual
19Lubricate threaded portion of No.1 rod cap screws with Johnson or Evinrude Outboard Lubricant and install rod cap
INotel Be sure alignment dot on rod cap matches dot on rodG71 20Using instructions supplied with OMC Alignment Fixture, PI 396749, install the fixture and torque the connecting rod screws in stages to 30-32 ftIbs(40-43 Nm) using OMC Torque Socket, PI 331638Torquing the screws without OMC Alignment Fixture PI 396749, or using an incorrect procedure, could cause permanent damage to the connecting rod and crankshaftTo maintain accurate torque values, keep extension length to minimum21Repeat Steps 19 and 20 for each remaining connecting rodf18l 22Thoroughly clean and degrease crankcase mating flange of the cylinder block with OMC Cleaning Solvent and let air dry23Apply OMC Locquic Primer to the mating flange of the crankcase and let air dryr:J9l 24Apply OMC Gel Seal" to the crankcase mating flange of the cylinder blockThe application must cover the flange evenly and consistently without being excessiveThe application must not come within 14 in(6,4 mm) of labyrinth seals or main bearings