1992 Johnson Evinrude "EN" 60 thru 70 Service Manual, P/N 508144, Page 140Get this manual
1n"J 9Using tool as drawn on Page 4-8, or equivalent, push crankcase taper pin toward intake manifold surfaceDo not use any tool smaller than taper pin bore to remove the pin t!J
r;Ql 10Loosen in stages and remove the main bearing screws and nutsRemove the crankcase flange screws
rw shaft to separate the or rubber mallet, tap upward on crank11Using rawhide crankcase and cylinder block12Lift straight up and remove crankcaser;2l 13Using an indelible marker, identify each connecting rod cap, connecting rod, and piston by cylinder numberMark them No.1 thru No.3 starting at the flywheel endr:tJl 14Using OMC Torquing Socket, PIN 331638, loosen in stages the rod cap retaining screwsDO NOT remove the screws