1992 Johnson Evinrude "EN" 60 thru 70 Service Manual, P/N 508144, Page 110Get this manual
Power Pack Removal 1Separate the power pack connector(s) Twist and remove the primary lead covers from the ignition coilsf21 2Noti.ce the position of the power pack ground lead before t=.l removmg any screws3Remove the screws and power packPower Pack Installation 1Clean the power pack mounting bosses to provide clean engine groundr:;] 2Carefully install the power pack ground lead where indi-
cated and install the retaining screwsTighten the screws to torque of 60-84 inIbs(7-9 Nm)3Apply isopropyl alcohol to the Amphenol connectorsAlign flat areas and carefully plug togetherSecure with wire retainer where used4Lightly coat the openings of the primary lead covers and install them on ignition coil terminalsObserve proper wire routing and ignition timingrefer to Ignition Coil Installation