1992 Johnson Evinrude "EN" 60 thru 70 Service Manual, P/N 508144, Page 80Get this manual
Inspection 1sl 1To test the solenoid windings, calibrate an ohmmeter on low ohms scale and connect between the purplewhite and black leads Meter should indicate 5.5 1.5 ohms2To test solenoid valve and seat: Lightly pressurize inlet fitting with alcohol and syringe With lever in run position, no fluid should enter inlet fitting With lever in prime position, fluid should come out both outlet fittingsf71 3To inspect or replace internal components, remove the four solenoid cover screwsf81 4When assembling solenoid, back up screws in their holes to engage original threads and tighten securelyInstallation 1Attach purplewhite leads and three hosesSecure large hose with tie strap2Install solenoid and bracketPosition ground lead under the inside bracket screw ill squeezing primer bulb until definite pressure is felt in the