1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 313Get this manual
Trim Sending Unit Adjustment 1Tilt the engine and engage the mooring bracket
rv 2Temporarily, install PIN 387278 thrust rod in the No.3
r2J 3Loosen the sending unit screws until only snug, so the
sending unit can be pivoted4Disengage the mooring bracketLower the engine against the thrust rodf3l 5Observe the trim gaugeIf the needle does not show center positiontilt the engine up and adjust the sending unit by pivoting it up or down6Lower the engine against the thrust rod to verify adjustmentRepeat Step 5, if necessary7After adjustment is correct, tilt the motor up, tighten the two sending unit screws, and remove the thrust rod