1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 302Get this manual
5Remove the four screws that retain the lower motor coversRemove the starboard cover
rg1 6Disconnect the three bullet connectors, and remove the port 7Raise the unit and lock it in place with the mooring bracketr;Ql 8Disconnect the bullet connector and two-pin connector for the trim senderPull the wires with braided tube through the stern bracketr:t1l 9Remove the ground wire from motor retaining screw using No.3 Pozi-Driv tool10Remove external snap rings from the upper pin11Use punch to remove the upper pin12Loosen the manual release valve, and retract the tilt cylinder rod