1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 272Get this manual
Installation of Cables on Engine i cables are disconnected at batteryThrottle Cable 1Remove the anchor block cover from starboard lower engine coverRemove cable retainerApply liberal amount of OMC Triple-Guard grease'" To prevent accidental starting of engine, verify that battery
rv greasethrottle cable and lubricate with OMC Triple-Guard 2Extend
3Verify that the remote control fast idle lever is down in the RUN position 4While rotating the propeller shaft, move the remote control handle from NEUTRAL to the FORWARD detent and then halfway back to NEUTRALThis positions the control for proper throttle cable adjustmenteffort
Failure to follow this procedure exactly might cause accelerated wear of shift system components and high shifting