1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 269Get this manual
OMC Long Life TM CablesInstallation
OMC Cable Adapter Kit, PIN must be used to install OMC Long Life cables into the remote control
1Remove three cover screws from remote control, and pull two halves apart
13611371 surfaceApply OMC Triple-Guard grease to all points 2Place housing half and cover half on flat
shown in figuresBe sure to grease the three cover screws' threaded holesCOB5630
1381 Lubricate outside of brass sleeves at control end of both remote control cables with OMC Triple-Guard grease
1391 4Place trunnionover cable over cable trunnions and caps casing guides sleeves1401 5Using a
332 inhex wrench, start the set screws into each end of both control end wire clamps
14111421 To Begin cable installations with housing half of control6install throttle cable, make certain fast idle lever is