1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 213Get this manual
1ol 13To assemble inner and outer seals to bearing housing, install outer seal retaining ring into its groove in the bearing housing l!J
1nl 14Apply OMC Gasket Sealing Compound to metal casing of each seal before installingApply OMC Triple-Guard grease to seal lips before installing inner sealInstall outer seal into bearing housing with lip facing outwardPress seal in until it makes contact with retaining ring
bearing housing using socket slightly smaller than the outside diameter of the sealWhen the seal is seated, install the inner retaining ringf.12l 16Remove the seal carrier assembly and thrust washer from the driveshaft17Remove the retaining ring with retaining ring pliersWear safety glasses and proceed with care to avoid unsnapping the ring from the pliers