1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 199Get this manual
Driveshaft Bearing Housing Service The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged rv 1Remove the twoPIdriveshaft bearing housing Puller Jaws, seals using OMC Puller Bridge, 432127, and OMC Large
PIN 432129Discard the seals2Remove the a-ring from the bearing housing and discard 3Clean the bearing housing in solvent to remove sealer from the seal bore and the a-ring groovef31 4Install new seals back to back in the bearing housing using OMC Seal Installer, PI 330268Apply OMC Gasket Sealing Compound to the metal casings of the seals before installingInstall the inner seal with flush lip facing toward the bearing housing, then the outer seal with extended lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing5Lightly apply OMC Triple-Guard grease to new a-ringInstall the -ring in top groove of the bearing housingDR2061