1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 195Get this manual
f13l 14 Insert small screwdriver under one end of the clutch dog spring and remove it from the groove by unwrapping it from around the clutch dogDiscard the springRemove the clutch dog pin
15Pull the clutch shaft out of the housing and slide the clutch dog off the rear of the shaftThe detent balls inside the rear of the shaft are not serviced and are available only as an assembly with the clutch shaft
Lift the reverse gearthrust bearingand thrust washer off the bearing housing
Do not remove the bearing inside the reverse gearIt is not serviced separately and is available only as an assembly with reverse gear
f'15l r:t6l 17Push the shifter pivot pin out of the housing Pull out