1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 187Get this manual
10 r,Ql 14Slide the
propeller shaft onto the shifter shaft, align the hole in the shaft with the hole in the clutch dog, install the pin and then, new clutch dog retaining springPosition three coils over each end ofthe pin, making sure none ofthe coils overlap or are loose
f11l 15Locate the propeller shaft assembly and align the forward bearing housing with the detent lever toward the topPush the detent lever down, into REVERSE positionBe sure the thrust bearing and the thrust washer are properly positionedInsert the propeller shaft assembly into the gearcase, being sure to align the shift housing pin with hole in forward end of gearcase housing f12l 16Lubricate new shift rod cover a-ring with OMC Triple-Guard greaseInstall the a-ring into the shift rod cover'13l 17Place the shift rod grommet and shift rod spacer (EX models) on the shift rodGrease the threaded end of the shift rod and insert it through the cover bushingTurn the shift rod while pushing it through the bushing to avoid damaging the a-ring13