1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 158Get this manual
3Remove the water tubeInspect the water tube grommet and replace if necessaryAssembly 1sl 1Apply OMC Adhesive sealant to the bottom flange of the adapterinner exhaust housingInstall new seal 19l 2
Install the water tubeInstall the adapterinner exhaust housing onto the exhaust housing
r,Ql 3Apply OMC, Gel-Seal" sealant to the adapter flange of the exhaust housingr:J1l 4Apply OMC Nut Lock to threads of the four retaining screws and torque to 60-84 in Ibs(7-9 Nm)Installation
1If removed, apply soapy water to the two lower mounts, and place the mounts in the exhaust housingOne side of mount is stamped "OUTSIDE" to indicate placementPosition the mount coversInstall the screws and torque them to 18-20 ftIbs(24-27 Nm)