1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 142Get this manual
The port head has temperature switch with two wires, the starboard head has switch with one wire23Rotate cylinder block so that starboard cylinder head surface is parallel with floor24 Repeat Steps 18 through 19 for starboard cylinders25Rotate cylinder block so that crankcase mating flange is facing up26Push all pistons to Top Dead CenterRemove numbered connecting rod caps [!!J 27Gently lower crankshaft assembly into place Orient all crankcase seal ring gaps facing up Locate tab on lower bearing seal housing in recess in crankcase
locate each center main bearing split sleeve on its dowel pinr:j9l 28Lubricate No.1 crankpin and bearing assemblies with Evinrude or Johnson Outboard LubricantSlowly pull No.1 connecting rod up to crankshaft and install bearings1201 29Lubricate threaded portion of No.1 rod cap screws with .Evinrude or Johnson Outboard LubricantAlign dot on rod cap with dot on the connecting rodInstall rod cap screws finger tightBe sure alignment dot on rod cap matches dot on rod and that both dots face flywheel30Using instructions supplied with OMC Alignment Fixture PIN 396749, install the fixtureUsing the OMC Torquing Socket PIN 331638, torque the connecting rod screws in stages to 30-32 ftIbs(40-43 Nm)