1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 140Get this manual
1sl 7Lubricate new lower housing a-ring with OMC TripleGuard grease and place the -ring on the lower housing1sl 8Lubricate seal lip with OMC Triple-Guard grease and place lower bearing seal housing on crankshaft
It is very important to notice that there are port and starboard pistons in this engineAll pistons are also marked "exhaust side Using these marks, orient the pistons with the correct cylinders and mark the bottom wrist pin hole with an indelible marker
f81 10It is very important to notice that the connecting rods have top and bottom diagonal oil hole will always face the flywheel19l 11Apply OMC Needle Bearing Grease to the 28 wrist pin bearingsInstall the bearings in the wrist pin boreAlign the bearings in the bore using OMC Wrist Pin Bearing Tool PIN 336660 r,Ql 12Place the two wrist pin thrust washers on the tool with flat side of the washers facing outr:J1l 13Support the piston in OMC Piston Cradle PIN 326572 with bottom wrist pin hole facing downOil the wrist pin bore and wrist pinInstall the connecting rod with the oil hole facing upInstall the wrist pin through the piston and connecting rod, pushing the tool out through the piston