1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 139Get this manual
L-L:- 243 :=S-J'
r:J1l 14Inspect center main bearing and split rings for excess wear, nicks or scratchesReplace if necessaryf121 15Inspect crankshaft rod bearings for excess wear, nicks or scratchesReplace if necessaryAssembly
Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson and Evinrude Outboard LubricantUse new wrist pin retaining rings, gaskets, seals, and a-rings during assembly
rv Sleevethe end of the crankshaft.and place new lower main 1Oil Use OMC CrankshaftBearing Installer, PIN 338647,
bearing onto crankshaft with lettered side facing the toolInstall bearing until it seats in the crankshaft
l=.J Crankshaft BearinglSleeve Installer, PIN 338647, and drive the
2Oil the end of the crankshaftPlace new sleeve in OMC