1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 134Get this manual
'8' 7Separate crankcase and cylinder blockIt may be necessary
to tap on crankshaft with rawhide or rubber mallet to loosen19l 8Remove upper seal from crankshaftDiscard the sealA new upper seal must be installed on assembly
Loosen in stages and remove cylinder head retaining screws, remove the cylinder heads
r:t1l 10Using an indelible marker, identify each connecting rod cap by cylinder numberRod No.1 is closest to the flywheel
r:;:;J 11Using OMC Torquing Socket PIN 331638, loosen in stages the rod cap retaining screwsDo not remove the screwsf13l 12Using one hand to support the piston, remove the rod cap screws with your other handRemove pistonReattach each rod cap to its rod as soon as the piston is removedEach cap is unique and can only be installed on its mated rodDo not allow rod to contact inside edge of piston