1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 122Get this manual
Function TestsQuikStart This ignition system incorporates QuikStartTM electronic starting, which automatically advances ignition timing when engine temperature is less than 1050 (41 C) and for approximately seconds each time the engine is started, independent of temperatureOnce QuikStart electronic starting has been canceled by engine temperature, the engine must be turned off before the ignition advance cycle can be repeated QuikStart electronic starting also incorporates an RPM limit that cancels the ignition advance when the engine speed exceeds approximately 1100 RPMVerification of QuikStart 1Install correct test propeller and start engine in test tankEngine temperature must be above 1050 (41 C) before proceedingStop the engine
engine linkage adjustments must be correct and idle RPM must be normal before proceeding Refer to Synchronization and Linkage Adjustments, Section 12Remove the engine cable bracketDisconnect whiteblack lead between power pack and port temperature switch