1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 116Get this manual
STEPPOWER COIL TEST
Ground Test 1Disconnect 6-pin Packard connector between stator and power pack2Attach 6-pin Packard test adapter from OMC Ignition Test Kit, PI 434017, to stator connector3Set peak-reading voltmeter to "POS" and" 500"
rv 4Alternately connect metermeter at each connection: stator leads, and clean engine groundbetween orange, orangeblack Crank engine and observe
Any reading indicates power coil is grounded Locate and repair ground, or replace stator assembly5If no reading is indicated in Step 4, go to Output TestOutput Test 1Set peak-reading voltmeter to "POS" and" 500"2Attach meter black lead to orange stator leadAttach meter red lead to orangeblack stator lead3Crank engine and observe meter: If meter shows 50 volts or higher, proceed to next step indicated in Troubleshooting Sequence Chart, Page 3-24 If meter shows less than 50 volts, check condition of wiring and connectors If wiring and connector condition is good, go to Ohmmeter TestOhmmeter Test