1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 99Get this manual
Ignition Coils and Power Pack Servicing Removal
1Remove the rectifierregulator cover and ignition coverDiscon nect the timing sensor plug
2Separate the 5-pin and 6-pin Packard connectors from the power pack
3Starting with the top ignition coildisconnect the primary leads and spark plug leadsRemove the screws securing the ignition coil to the cylinder block4After removing the bottom ignition coil screws, remove the ignition coil and power pack from the cylinder blockNote Do not attempt to remove the radio frequency shield from the power packInstallation
'3l 1Position the power pack and bottom ignition coilPosition the lock washerflat washerand power pack ground lead on the bottom port ignition coil screwInstall screw finger tightr;l 2Place lock washer and flat washer on bottom starboard ignition coil screw and install the screwTighten both ignition coil screws to 50-95 inIbs(5,6-10,7 Nm)