1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 79Get this manual
7Install the carburetor body to float cover gasketr::;] 8Clip float valve to floatInstall float assemblyTighten
hinge pin retaining screw securelyInstall gasket to carburetor body1331 9Adjust float height with chamber invertedFloat must be level with gasket surface '32 in(0,8 mm)If adjustment is required, do not put pressure on float valve and seat10Adjust the float drop with carburetor body in normal positionThe drop dimension to bottom offloat should be between '116-11;8 in(17-28 mm)11Install high speed fuel orifice with OMC Driver, PIN 317002, and install float chamber plugTorque plug to 30-35 inIbs(3-4 Nm)341 12Install float cover and retaining screwsBack out screws in their holes to engage original threadsTorque screws in sequence to 18-24 inIbs(2-3 Nm)1351 13Install new O-ring seal and attach main body to throttle bodyTorque mounting screws in an "X" pattern to 45-55 inIbs(5-6 Nm)