1992 Johnson Evinrude "EN" 60 deg Loop V Service Manual, P/N 508146, Page 13Get this manual
1 Symbols
Throughout this service manual, symbols are used to interpret electrical troubleshooting results or to assign values in drawingsElectrical
[!] This symbol indicates continuity or very low resistanceThis symbol indicates no continuity or very high resistanceUse an ohmmeter calibrated on high ohms scale, or continuity light, to test continuityDR4204
] When "00" shows on the meter face, no continuity, or very high
3 resistance, is indicatedThe symbol is referred to as infinityWhen follows value on the meter face, the procedure is measunng voltageWhen "0 follows value on the meter face, the procedure is measuring resistancen is the symbol for ohm, the unit of measurement for resistanceValues