1992 Johnson Evinrude "EN" 40 thru 55 Service Manual, P/N 508143, Page 310Get this manual
t:2p C02817
1431 7Push core wire Q) (from engine end) through wire clamp Q) until wire is flush, 132 in(0,8 mm), with end of casing guide 1441 8Turn in set screw on large end of wire clamp until ittouches core wire, then tighten one more full turn to kink and position core wire1451 9Grease trunnion pocket in housing halfLift throttle cable and rotate cable forward until trunnion cap can be inserted into trunnion pocket1461 10Position throttle lever by hand to align rear hex screw with access hole in controlInsert hex wrench through hole and tighten second set screwr:;;l 11The throttle lever must be in the idle position before reassemblyMove the throttle lever forward, toward the front of housing half, until it contacts the stop (Q1481 12To install shift cable, grease trunnion pocket in cover halfPlace casing guide of shift cable between halves of shift lever and shift cable trunnion cap in its pocketGrease outside surface of wire clampInsert clamp through shift lever and casing guide1431 13Push core wire Q) (from engine end) through wire clamp Q) until wire is flush, 132 in(0,8 mm), with end of casing guide 1491 14Turn set screw in on large end of clamp until it touches core wire, then tighten one more full turn to kink and position core wire