1992 Johnson Evinrude "EN" 40 thru 55 Service Manual, P/N 508143, Page 305Get this manual
Assembly
ill in operator losing control of direction and amount of
propeller thrust
Failure to follow assembly instructions closely could result
Lubricate friction points on mechanical parts with OMC Triple-Guard grease
1To reassemble control handle, place control handle knob on control handle and secure with screwTighten screw to torque of 20-30 inIbs(2,3-3,4 Nm) Position trimtilt switch into control handle coverSecure with screw Secure control handle cover to control handle with four screws Apply OMC Triple-Guard grease to slide return springPlace slide return spring onto control handle as shown Compress the slide return spring with neutral lock slide and snap neutral lock slide onto control handleAfter installed, spring tension must be felt when pulling up on neutral lock slide Install plate with two screws to control handleTighten screws to torque of 25-35 inIbs(2,8-3,9 Nm)2Install the key switch, warning horn, and emergency stop switch, if removedApply OMC Black Neoprene Dip to the key switch terminals20 3th.reads of the shift lockout cam screw with OMC LocqUlc Primer