1992 Johnson Evinrude "EN" 40 thru 55 Service Manual, P/N 508143, Page 251Get this manual
AssemblyGate Cam Models 1.jl 1If the reverse gate was removed during disassembly, install L!.J reverse gatebushings ,and shafts to jet housingPosition shafts so holes align with holes where retaining screws make contact2Torque screws to 60-84 inIbs(7-9 Nm)After installation, check to make sure the reverse gate moves freely t=J assemble in any other position
3Place roller into cam in position shownThe roller will not
f31 4Place cam roller on reverse gate stud, and torque nut to 60-84 inIbs(7-9 Nm) 5Install bushing
, eccentric nutand cam screw
Before tightening cam screw, adjust reverse gateRefer to Gate AdjustmentAssemblyGate Linkage Models f5l 1Position gate to housing with wave washer and shafts to jet housing