1992 Johnson Evinrude "EN" 40 thru 55 Service Manual, P/N 508143, Page 233Get this manual
2930 7ail, then install new bearings in the bearing housing using OMC Bearing Installer, PI 326562 Press
against the lettered side of the bearing to prevent damage to the bearings when installing
fJ1l32 8Use OMCSeallnstalier PI 326551 to install two new
seals back to back in the rear of the bearing housingApply OMC Gasket Sealing Compound to the metal casings of the seals before installingInstall the inner seal with lip facing toward the bearing housing, then the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installinghousing a-ringInstall the a-ring in its groove in the housingInstall new a-rings on the retaining screws
COA3559
1331 9Lightly apply OMC Triple-Guard grease to new bearing
Driveshaft Bearing Housing Service
rt:J=J If the needle bearing in the housing is worn, the bearing
and housing must be replaced as an assembly