1992 Johnson Evinrude "EN" 40 thru 55 Service Manual, P/N 508143, Page 219Get this manual
12 up, insert wedge end of the tool with flat side facing end of detent springWhen the tool is flush with the clutch dog, press the retaining pin through the clutch dog, pushing out the toolr:jJl 11Secure the pin with new retainer springPosition three coils over each end of the pin, making certain no coils of the spring overlap!14! 12Install the forward gear thrust washer with chamfered edge facing into the gearcaseApply OMC Needle Bearing Assembly Grease to the forward gear thrust bearingPlace the bearing on shoulder of the gear and install the gear, r:J6l 14Place one of the thrust washers onto the driveshaft with chamfered edge facing downInstall the thrust bearing Place the remaining thrust washer onto the driveshaft with chamfered edge facing upLightly coat the shim(s) with OMC Needle Bearing Assembly grease and place them into the bearing housingSlide bearing housing onto driveshaft!Note! Position items