1992 Johnson Evinrude "EN" 40 thru 55 Service Manual, P/N 508143, Page 214Get this manual
Propeller Shaft Bearing Housing Servicing
Inspect the bearings in placeIf bearing is removed for any reasonit must be replaced
291.f31l 1To remove the two seals, front and rear bearings, use OMC Beari ng Pu IIer PI 432130 attached to either OMC Slide Hammer PIN 432128 or OMC Puller Bridge PIN 432127Thoroughly clean the housing in solvent2Install new bearings in the bearing housing using OMC Bearing Installer PI 334997r:;:;] Oil and place new forward bearing on the tool with lettered side of the bearing facing the toolInstall the bearing until the tool contacts the housing15500
Oil and place new rear bearing on the tool with lettered side of the bearing facing the toolInstall the bearing until the tool contacts the housing