1992 Johnson Evinrude "EN" 40 thru 55 Service Manual, P/N 508143, Page 161Get this manual
Assembly
Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant
INotel Use new gaskets, seals, and a-rings during assembly[':;11Apply OMC Gasket Sealing Compound to outside diameter LJ of new upper crankshaft sealInstall the seal with lip facing bearing using OMC Seal Installer, PIN 334500Coat the lip of the seal with OMC Triple-Guard greaser:;l2Apply OMC Gasket Sealing Compound to outside diameter of two new lower crankshaft sealsInstall both seals with lip facing up using OMC Seal Installer, PIN 334998Liberally apply OMC Moly Lube between the sealsf313Apply OMC Needle Bearing Grease to the 28 wrist pin bearingsInstall the bearings in the wrist pin boreAlign the bearings in the bore using OMC Wrist Pin Bearing Tool, PIN 336660f411sl4Place the two wrist pin thrust washers on the tool with flat side of the washers facing out5The connecting rod has no specific orientationSupport the piston in OMC Piston Cradle, PIN 326573Oil the wrist pin bore and wrist pin24907