1992 Johnson/Evinrude EN 2.3 thru 8 outboards Service Manual, Page 250Get this manual
6Install pawl and links in positionInstall retaining ring with sharp side facing outr:J1l 7Apply OMC Triple-Guard grease or Lubriplate 777 to the handle end of the starter ropeThread the starter rope through the handleKnot the end of the rope and press the starter rope into the channel of the rope anchor, with end of starter rope butting firmly against end of channelPress the anchor into the handleRemove slip knotTug on end of starter rope to seat the knot against the pulleyAllow the starter rope to wind slowly onto the pulley8Check the operation of the pawl when the starter rope is pulled outThe pawl should extend when the starter rope is pulled and retract when the starter rope recoilsInstallation 1Install the starter lockout cable into the starter housing f12l 2Position the starter assembly onto the powerheadInstall