1992 Johnson/Evinrude EN 2.3 thru 8 outboards Service Manual, Page 247Get this manual
3Position spring retainer
on pulley as shown
r:Jl 4Lubricate spring with OMC Triple-Guard grease or Lubriplate 777Hook end loop of spring to pulley roll pin'al 5Install cup and stop assembly with washer over pulleyBe sure spring is positioned through tabs as shown6Temporarily insert shoulder screw through cup and stop assemblyInstall nut on the shoulder screw to secure assembly7While pressing down on pulley, turn pulley clockwise and wind spring into cup and stop assembly until outside loop of spring engages outside face of assembly8Slowly release pulley, relieving spring tensionHold starter assembly together and remove shoulder screws
COAl178
L!.J idler gear on idler gear arm
9Position idler gear arm spring
in idler gear arm Place
10Clean threads of shoulder screw to remove adhesiveSpray threads with OMC Locquic Primer
El gear arm assembly over pulleyBe sure stop of idler gear
arm is positioned between the two tabs assemblyInstallation