1992 Johnson/Evinrude EN 2.3 thru 8 outboards Service Manual, Page 230Get this manual
r:J7l 14Inspect the driveshaft bearing in placeIf necessary, remove the bearing and sleeve using the slide hammer and OMCTwo-Jaw Puller, PIN 391012The jaws ofthe puller must be reversed so the jaw tips are facing inwardUse stiff rubber band to keep the jaws togetherr:J8l 15Inspect the pinion bearings in placeIf necessary, remove the bearings using OMC Bearing Remover, PIN 319880Place shop cloth inside the gearcase to catch the bearings and toolIf pinion bearings are removed for any reason, they must be replaced r,g1 16Temporarily install the gearcase head into the gearcase with the two screws, finger tightUsing OMC Small Puller Assembly, PIN 432131, remove propeller shaft sealWhen installing the puller on the seals, be sure the jaws catch the seals and not the bushing in the gearcase head 1201 17Remove the driveshaft seals from