1992 Johnson/Evinrude EN 2.3 thru 8 outboards Service Manual, Page 180Get this manual
Assembly
r::=J Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant
INotel Use new gaskets, seals, and O-rings during assembly1If removed, install wrist pin bearing using OMC Bearing Installer and Remover, PIN 327645When installing wrist pin bearing, the oil hole must align with the hole in rod end 12311241 2Using OMC Cone, PI 333142, and Driver, PIN 333141, install one snap ring in groove of piston When installed, gap of the ring should be positioned opposite groove in the piston
'" To avoid personal injury, use insulated gloves when handling pistons that have been heated1251 3Heat the piston to 200400 (93204 C)Using OMC Piston Cradle, PI 326573, and OMC Pressing Pin, PIN 333141, oil the wrist pin and start it into the piston opposite the installed retaining ringDo not allow the wrist pin to enter the piston cavity0 0