1992 Johnson/Evinrude EN 2.3 thru 8 outboards Service Manual, Page 158Get this manual
Assembly
r:::-=J Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant
INote Use new gaskets and seals during assemblyf811gl1If removed, install new upper and lower ball bearings E.J using OMC Bearing Installer, PIN 115309When pressing on the bearings, support the crankshaft between the two counterweights and press against lettered side of the bearing2Apply coat of oil to wrist pin and wrist pin hole in pistonr,Ql3Insert wrist pin through either side of pistonOil wrist pin bearing and place into connecting rodPosition the connecting rod into piston with the arrow mark on piston top pointing to bottom of the crankshaftInstall wrist pin using suitable toolInstall new wrist pin retaining rings
LJ expander just enough to slip it over the