1992 Johnson/Evinrude EN 2.3 thru 8 outboards Service Manual, Page 125Get this manual
Ohmmeter Test
A.II ohmmeter tests must be made with engine NOT runnmg1Disconnect 6-pin Packard connector from ignition module
f61 2Attach 6-pin Packard test adapterfrom OMClgnition Test Kit, PIN 434017, to engine harness connector
Engine harness lead colors and test adapter lead colors do not matchWhen testing particular engine harness lead, be sure to use appropriate test adapter lead according to connector terminal locationrJl 3Calibrate an ohmmeter on appropriate scaleConnect meter leads between blackyellow lead, terminal liE" and clean engine ground The meter must show high reading4Momentarily press inward on the stop button The meter must show low reading