1992 Johnson/Evinrude EN 2.3 thru 8 outboards Service Manual, Page 113Get this manual
Ohmmeter TestStop Button
All o.hmmeter tests must be made with the engine NOT runnmg1Most steering emergency stop devicecontain combination stop button
When the clip and lanyard assembly is removed, the emergency stop device is in the STOP position When the clip and lanyard assembly is installed, the emergency stop device is in the RUN position To stop the engine when the clip and lanyard assembly is in place, press inward on the button2Install the clip and lanyardf51 3Calibrate an ohmmeter on appropriate scaleConnect meter leads between stop button 1-pin Amphenol connector and clean engine ground The meter must show high reading 4Momentarily press inward on the stop button The meter must show low reading5Remove the clip and lanyard The meter must show low readingDR4097