1992 Johnson/Evinrude EN 2.3 thru 8 outboards Service Manual, Page 110Get this manual
Ignition Coil Replacement Removal
1Twist and remove cover to remove the spark plug lead and primary leads from the ignition coil2Notice the fastener and washer orientation before removing any screws3Remove the coil mounting screws and remove the coil and washersInstallation
rv f21 theAssemblecoil on the powerheadof washers tighten the 1the correct sequence and locate ignition Install and
retaining screws to torque of 48-96 inIbs(5,4-10,8 Nm)2Apply light coating of OMC Triple-Guard grease to the ribbed portion of the spark plug ceramics and to the openings of each of the spark plug lead coversInstall the spark plug leads3Apply light coating of OMC Triple-Guard grease to the opening of each primary lead cover and install the coversObserve the proper wire routing and ignition timing The orange blue primary lead must be connected to the No.1 ignition coil