1992 Johnson/Evinrude EN 2.3 thru 8 outboards Service Manual, Page 87Get this manual
Assembly Before proceeding, be sure that all parts are perfectly cleanBe sure that all replacement parts match original ones in size and shapeReplace all gaskets, O-rings, and sealing washers each time you assemble carburetor1Install the high-speed orifice into the nozzle wellPosition the nozzle well and upper gasket on the carburetor body rJl 2Connect the nozzle well to the carburetor with new idle lift
tube3Install the valve seat and gasket 4Install the hinge pinfloatand float valve
dH t;nClHl
r_ 2_TH_ RU_6 H_P_
5Check for correct positioning of float levelThe float level controls the height of fuel in the float chamber and is critical with regard to carburetor calibration and function Turn carburetor body upside down and hold so gasket surface is horizontalThe weight of the float will close the float valve needleRest OMC Float Gauge, PIN 324891, on gasket surface and slide gauge up, next to floatTop of float should be between notches on gauge