1992 Johnson/Evinrude EN 2.3 thru 8 outboards Service Manual, Page 76Get this manual
] 7Install valve seatr:J2l 8float valve into valve seat, and install float hinge pm ] 9Install needle jet and main jet r:t3l 10Install slow speed adjustment screw carburetor body11Install new float chamber gasket
spring on
DRC3548
1141 12Check for correct positioning of float hingeFloat level
controls the height of fuel in the float chamber and is critical to carburetor calibration and functionTop of float hinge should be 0.090 in(2,3 mm), measured from the top of the gasket
13Install float14Install float chamber on carburetor body15Using new gasket, install drain screw on float chamberInstallation