1991 Johnson/Evinrude Models "EI" 40 thru 55 Service Manual, Page 300Get this manual
431 7Push core wire CD (from engine end) through wire
until wire is flush, guide 132
Q) in(0,8 mm), with end of casmg
r;;1 8Turn in set screw on large end of wire clamp until it touches core wire, then tighten one more full turn to kink and position core wire
Grease trunnion pocket in housing halfLift throttle cable and rotate cable forward until trunnion cap can be inserted into trunnion pocketPosition throttle lever by hand to align rear hex screw with access hole in controlInsert hex wrench through hole and tighten second set screw
1461 101471 11