1991 Johnson/Evinrude Models "EI" 40 thru 55 Service Manual, Page 241Get this manual
AssemblyGate Cam Models
r.jl 1If the reverse gate was removed during disassembly, install reverse gatebushings ,and shafts to jet housingPosition shafts so holes align with holes where retaining screws make contact2Torque screws to 60-84 inIbs(7-9 Nm)After installation, check to make sure the reverse gate moves freely
3Place roller into cam in position shownThe roller will not assemble in any other positionPlace cam roller on reverse gate stud, and torque nut to 60-84 inIbs(7-9 Nm)
5Install bushingeccentric nutand cam screw Before tightening cam screw, adjust reverse gateRefer to Gate AdjustmentAssemblyGate Linkage Models
151 1Position gate to housing with wave washer CD, bushings Q), and shafts to jet housing2Torque screws to 60-84 inIbs(7-9 Nm)After installation, check to make sure reverse gate moves freely