1991 Johnson/Evinrude Models "EI" 40 thru 55 Service Manual, Page 237Get this manual
8 1al 13To assemble inner and outer seals to bearing housing, install outer seal retaining ring into its groove in the bearing housing
1nl 14Apply OMC Gasket Sealing Compound to metal casing of
before installationApply OMC Triple -Guard grease to seal lips before installing inner sealInstall outer seal into bearing housing with lip facing outwardPress seal in until it makes contact with retaining ringl!.J bearing housing using socket slightly smaller than the
1101 r:t;l 15Install inner seal with lip facing outwardTap seal into
outside diameter of the sealWhen the seal is seated, install the inner retaining ring