1991 Johnson/Evinrude Models "EI" 40 thru 55 Service Manual, Page 209Get this manual
up, insert wedge end of the tool with flat side facing end of detent springWhen the tool is flush with the clutch dog, press the retaining pin through the clutch dog, pushing out the toolf131 11Secure the pin with new retainer spring Position three coils over each end of the pin, making certain no coils of the spring overlap r:t1l f12l 10With holes in the clutch dog and shifter shaft lined
1141 12Install the forward gear thrust washer with chamfered
edge facing into the gearcase
151 13Apply OMC Needle Bearing Assembly Grease to the
forward gear thrust bearingPlace the bearing on shoulder of the gear and install the gear