1991 Johnson/Evinrude EI Outboards 2.3 thru 8 Service Manual, Page 223Get this manual
12Position the two thrust washers and thrust bearing on the pillionPlace thrust washer with inside chamfered edge against pinionThen place thrust bearing on pinion Position thrust washer with chamfered outside edge on the pinion with the chamfered edge away from pinion Place the gearcase in the position shown and install pInion
1331 14Install the forward gear by positioning it in the gearcase
Insert the propeller shaft into the forward gearPull up sharply on the shaft and you will feel the forward gear snap into positionRemove the propeller shaftler shaft
1341 15Position the reverse gear and thrust washer on the propelINotel The outside chamfered edge of thrust washer goes toward